Loading ...
Loading ...
Loading ...
14 English
ADJUSTING THE LEVEL
Make sure the refrigerator is level so that you can
make final adjustments. Use a level to test if the
refrigerator is level both side to side and back to
front. If the refrigerator is not level, you will not
be able to get the doors perfectly even, which
may cause moisture condensation and increased
energy bills. Below is an example of how to level
the refrigerator if the left side of the refrigerator is
lower than the right side.
flat-blade screwdriver (-)
Control Lever
How to adjust the level
1. Open the freezer drawer and remove the lower
basket.
2. Insert a flat-blade screwdriver (-) into the notch
on the left control lever, and turn it counter-
clockwise to level the refrigerator. (You turn the
lever clockwise to lower the refrigerator and
counterclockwise to raise it.)
Both control levers must be touching the
floor to avoid possible personal injury or
property damage because of tipping.
If the right side is lower, perform the same
procedure, but with the right control lever.
It is difficult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever. Instead, refer to the
next page for the best way to make minor
adjustments to the doors.
CAUTION
MAKING MINOR
ADJUSTMENTS TO THE DOOR
OR IN DOOR
Remember, a leveled refrigerator is necessary
for getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.
Adjustment
part
Fixed part
The left door is fixed. To make minor
adjustments between doors, adjust only
the right door.
Snap ring
The height of a door or in door can be adjusted
using the provided snap rings, which come in
4 different sizes (1 mm, 1.5 mm, 2 mm, and
2.5mm).
To adjust the height of a door
Check the height difference between the doors,
and then raise and hold the lower door.
• Insert the snap ring in the gap between the in
door and the HINGE-SHAFT.
(applicable models only)
RF30KMED_DA68-02894B-04_EN.indd 14 2018-07-04 8:25:12
Loading ...
Loading ...
Loading ...