Loading ...
Loading ...
Loading ...
– 61 –
MAINTENANCE AND SECURITY
Replacing the Projection Lamp
This projector uses the following lamps.
Replacement Lamp LV-LP42
Contact the Canon Customer Support Center when purchasing a replacement lamp.
Warning:
Precautions when replacing lamps that stop working
If the illumination suddenly stops when the projector is in use or after you turn it on, the lamp may
be broken. In this case, never attempt to replace the lamp by yourself. Always request service from
the Canon Customer Support Center.
Additionally, with ceiling-mounted projectors, the lamp may fall out when you open the lamp cover
or while you are attempting to replace it. During replacement, stand to the side of the lamp cover,
not directly under it. If the lamp breaks and any glass shards or other pieces get in your eyes or
mouth, consult a doctor immediately.
Caution:
Before replacing the lamp, always turn off the projector, unplug it after the cooling fan stops, and
wait at least 45 minutes. Do not touch the lamp immediately after turning the projector off. It is very
hot initially and poses a risk of burns.
• Be sure to use the specified lamp.
• Contact the Canon Customer Support Center for further information. This can also be
purchased from the Canon website.
• Do not touch the inner glass surface when you replace the lamp. Doing so may cause
deterioration to the projector’s performance.
• Handle lamps with care. Impact or abrasion may cause lamps to rupture while they are in use. If
a lamp ruptures, contact the Canon Customer Support Center and follow the instructions in
“Precautions when replacing lamps that stop working” (P8).
• When replacing the lamp, do not remove any screws other than those specified.
1.
Remove two screws on the
lamp cover.
Loading ...
Loading ...
Loading ...