Loading ...
Loading ...
Loading ...
If and when 231
Safety First Operating instructions Tips and Maintenance Technical Data
Box spanner for wheel bolts
Jack. Before you return the jack to the tool box, you must fully wind in the
claw. The crank must then be folded tight against the side of the jack.
The removable towing brack
et
44)
, the key for unlocking the sunroof in an
emergency
44)
and the anti-theft wheel bolt adaptor
44)
are stored next to the
vehicle tools.
Adapter for anti-theft wheel bolts
We recommend you carry the wheel bolt adapter
44)
in the vehicle tool kit at
all times.
The code number of the anti-theft wheel bolt is stamped on the front of the
adapter. You will need this number to replace the adapter if lost. Make a note
the code number of the anti-theft wheel bolt and keep it in a safe place - but
not in your vehicle.
WARNING
• Do not use the hexagonal socket in the screwdriver handle to tighten
the wheel bolts. It is not suitable for tightening the bolts to the necessary
torque. This may be an accident risk.
• The jack supplied by the factory is only designed for changing wheels
on this model. Never attempt to use it for lifting heavier vehicles or other
loads. Risk of injury.
• Use the jack only on firm, level ground.
• Never start the engine when you have raised the vehicle on the jack.
Risk of accident.
• Never place your body (e.g. arm or leg) underneath the vehicle if it is
only supported by the jack Risk of injury.
• If you have to work underneath the vehicle, you must use suitable
stands additionally to support the vehicle - Risk of accident!.
Taking out the spare wheel
1. Lift the cover ⇒ fig. 153 located on the floor of the luggage
compartment, next to the tailgate lock.
2. Pull the ring of the rubber seal upwards.
3. Remove the box spanner from the vehicle tools.
4. Fit the box spanner on the bolt, to the maximum, and hold in this
position. At the same time press the safety ring
downwards ⇒ .
5. Turn the box spanner several times to the left, until the spare
wheel can be fitted, hanging from a wire, vertically behind the
vehicle.
6. Separate the plastic pieces so that they may be inserted into the
central aperture of the rim and so free the wheel.
A
6
A
7
Fig. 153 Taking out the
spare wheel
A
A
A
B
A
C
A
D
A
C
Alhambra angles Seite 231 Donnerstag, 13. Oktober 2005 12:56 12
Loading ...
Loading ...
Loading ...