Loading ...
Loading ...
Loading ...
(137,1)
北米Model "A3210BE-C" EDITED: 2019/ 11/ 28
button (for unlocking of all of the doors
and the rear gate) is extremely short,
the system may not respond.
& Unlocking the rear gate
S02AQ05
Press the rear gate unlock button to unlock
the rear gate.
An electronic chirp will sound twice and the
hazard warning flashers will flash twice.
& Vehicle finder function
S02AQ07
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the
lock/arm button three times in a 5-second
period will cause your vehicle’s horn to
sound once and its hazard warning
flashers to flash three times.
NOTE
If the interval between presses is too
short when you press the lock/arm
button three times, the system may
not respond to the signals from the
remote transmitter.
& Sounding a panic alarm
S02AQ08
To activate the alarm, press the “PANIC”
button once.
The horn will sound and the hazard
warning flashers will flash.
To deactivate the panic alarm, press any
button on the remote transmitter. Unless a
button on the remote transmitter is
pressed, the alarm will be deactivated
after approximately 30 seconds.
& Setting audible signal opera-
tion (models without “keyless
access with push-button start
system”)
S02AQ09
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
Perform the following steps to deactivate
the audible signal. You can also use the
same steps to restore the function.
1. Sit in the driver’s seat and shut all
doors and the rear gate.
2. Press and hold the “ ” button of the
power locking switch and insert the key
into the ignition switch and pull it out at
least 6 times within 10 seconds.
3. Open and close the driver’s door once
within 10 seconds. The hazard warning
flashers flash 3 times to indicate comple-
tion of the setting.
Your SUBARU dealer can perform the
above procedure for you. Also, for models
with a combination meter display, the
setting can be changed using the display.
For details, refer to “Menu screens”
FP197.
& Replacing the battery
S02AQ12
Refer to “Replacing key battery” FP475.
– CONTINUED –
Remote keyless entry system
135
2
Keys and doors
Loading ...
Loading ...
Loading ...