Loading ...
Loading ...
Loading ...
49-2000385 Rev. 1 21
CARE AND CLEANING
OVEN DOORS (Cont.)
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Starting on the left side, with the door at the same
angle as the removal position, seat the indentation of
the hinge arm into the bottom edge of the hinge slot.
The notch in the hinge arm must be fully seated into the
bottom of the slot. Repeat for right side.
3. Fully open the door. If the door will not fully open, the
indentation is not seated correctly in the bottom edge of
the slot.
4. Push the hinge locks up against the front frame of the
oven cavity, to the locked position.
5. Close the oven door.
OVEN LIGHT
Oven Light Replacement
WARNING
SHOCK OR BURN HAZARD:%HIRUH
replacing oven light bulb, disconnect the electrical power to
the oven at the main fuse or circuit breaker panel. Failure
to do so may result in electric shock or burn.
CAUTION
BURN HAZARD: The glass cover and
bulb should be removed when cool. Touching hot glass
with bare hands or a damp cloth can cause burns.
1. Disconnect power at the main fuse or circuit breaker
panel.
2. Remove oven racks.
3. Slide a flat blade screwdriver between the housing and
the glass light cover.
4. Support the glass light cover with two fingers to prevent
WKHFRYHUIURPIDOOLQJWRWKHERWWRPRIWKHRYHQ%H
careful not to chip the oven coating.
5. Gently twist the screwdriver blade to loosen the glass
light cover.
6. Remove the glass light cover.
7. Remove the bulb by firmly grasping and sliding the
bulb straight out until the two prongs have cleared the
ceramic holder.
8. Do not touch the glass of the new replacement bulb
with your fingers. It will cause the bulb to fail when it
lights. Grasp the replacement bulb with a clean towel or
facial tissue with the prongs facing down. Align the two
prongs in the ceramic holder, pressing gently until the
bulb is securely in the ceramic socket.
9. Slide the protective lens into the holder and push until
the clips snap into the housing.
10. Reconnect power.
Push hinge locks up to lock
Hinge
lock
Hinge
arm
Indentation
%RWWRP
edge of slot
Hinge arm
Loading ...
Loading ...
Loading ...