Loading ...
Loading ...
Loading ...
5. Draw a horizontal line (#4 in the illustration) parallel to the headlamp
bulb center line (#3 in the illustration) but 0.82 inches (20.9 mm) (#5 in
the illustration) below it.
6. Take appropriate measures to prevent any influence of other lights.
7. Start the engine.
8. Turn the low beam of the headlamps on.
9. On the paper, observe the portion of the light pattern with a distinct
area of higher intensity light. Check that the top edge of this high
intensity area is at the horizontal reference line (#4 in illustration) and
below the cross-hatched area shown in the illustration. If it isn’t, adjust
the headlamps in the vertical direction.
Use this illustration to check the headlamp aim pattern as it should
appear on the paper.
3. Horizontal line at headlamp bulb center.
4. Horizontal lines for headlamps, 0.82 inch (20.9 mm) below bulb
center.
5. 0.82 inch (20.9 mm).
6. High intensity area of light pattern.
Adjusting the headlamp aim
IMPORTANT: Both the inboard and outboard vertical aim screws must
be turned the same amount in the same direction. Do NOT turn the
screws different amounts or in different directions.
2007 Low Cab Forward Truck (lcf)
Supplement
USA (fus)
Lights
43
Loading ...
Loading ...
Loading ...