Loading ...
Loading ...
Loading ...
||
MAINTENANCE AND SERVICE
* Option/accessory.
374
NOTE
Tighten the screws to 30 Nm. Check the tor-
que with a torque wrench.
Fitting
1. Lower the battery into the battery box.
2. Move the battery inward and to the side until
it reaches the rear edge of the box.
3. Tighten the clamp that holds the battery.
4. Connect the ventilation hose.
> Check that it is correctly connected to
both battery and outlet in the body.
5. Connect the red positive cable.
6. Connect the black negative cable.
7. Press in the rear cover. (See earlier section
"Removal".)
8. Fit the rubber moulding. (See "Removal".)
9. Align the front cover and secure it with the
clips. (See "Removal".)
For more information on the car's starter battery,
see Starter battery - general (p. 370) and Jump
starting with another battery (p. 275).
Battery - Start/Stop
Cars with the Start/Stop function are equipped
with a support battery in addition to the starter
battery.
Cars with the Start/Stop function are equipped
with two 12 V batteries - one extra powerful bat-
tery for starting and one support battery that
helps during the Start/Stop function's starting
sequence.
For more information on the Start/Stop function,
see Start/Stop* (p. 284).
For more information on the car's starter battery,
see Jump starting with another battery (p. 275).
The following table shows specifications for the
starter battery and support battery respectively in
cars with Start/Stop function.
Loading ...
Loading ...
Loading ...