Loading ...
Loading ...
Loading ...
WHEELS AND TIRES
}}
* Option/accessory.
317
Tire sealing system* – sealing a
hole
The tire sealing system can be used to tempo-
rarily seal a hole in the tread surface of a tire.
Stage 1: Sealing the hole
1. Peel off the speed limit sticker and affix it to
the steering wheel hub where it will be
clearly visible to the driver.
2.
Ensure that the on/off switch is in position 0
(the 0 side of the switch should be pressed
down).
WARNING
Contact with the sealing compound may
cause skin irritation. If contact occurs, wash
the affected area immediately with soap and
water.
3. Unscrew the orange cover over the bottle
holder on the compressor and unscrew the
cap on the bottle of sealing compound.
NOTE
Do not break the seal on the bottle. This
occurs automatically when the bottle is
screwed into the holder.
4. Screw the bottle into the bottle holder as far
as possible.
WARNING
The bottle is equipped with a catch to keep it
securely in place and help prevent sealing
compound leakage. Once in place, the bottle
cannot be unscrewed. This must be done by a
trained and qualified Volvo service technician.
5. Remove the valve cap from the tire’s inflation
valve and screw the tire sealing system’s
hose connector onto the valve as tightly as
possible by hand. Be sure the air release
valve on the hose is completely closed.
6. Connect the electrical wire to the nearest
12-volt socket in the vehicle.
NOTE
Be sure that none of the other 12-volt sock-
ets is being used while the compressor is in
operation.
7. Start the vehicle’s engine.
WARNING
The vehicle´s engine should be running when
the tire sealing system is used to avoid bat-
tery drain. Therefore, be sure the vehicle is
parked in a well ventilated place, or outdoors,
before using the system.
8. Start the tire sealing system’s compressor by
pressing the on/off switch to position I.
Loading ...
Loading ...
Loading ...