Loading ...
Loading ...
Loading ...
35
ENGLISH
4
Soak the lter in clean water and then rinse under
running water to make sure no detergent residue
remains.
Caution
• Rinse thoroughly after washing until no detergent
bubbles appear. Detergent residue left on the lter may
shorten its lifespan or cause product malfunction.
• Take care not to damage the lm or wires inside the lter
during cleaning. If the lter is damaged, stop using the
product and call for service.
• Do not attempt to disassemble the top and bottom
sections of the PM 1.0 Black Filter.
5
Prop the lter at an angle out of direct sunlight and
allow to dry completely for 12 – 24 hours.
6
Place the PM 1.0 Black Filter back in the lter tray.
• Assemble the lter with the two circles on its side
facing as shown.
7
Place the deodorizing Black Filter on top of the PM 1.0
Black Filter, aligning its slots with the tabs on the top
of the ultra ne lter set.
Note
The PM 1.0 Black Filter is electrically charged. During the
initial startup you may hear a charging sound.
Cleaning the Dust Sensor
The PM1.0 (super ultra-ne dust) sensor is used to
detect dust density levels. Clean it periodically for best
performance.
1
Press the lter tray's release button to slide open the
lter tray. Remove the tray completely.
2
Dampen one end of a cotton swab and use it to clean
the lens. Use the dry end of the cotton swab to wipe
the lens dry. You can also use cotton balls.
Loading ...
Loading ...
Loading ...