Loading ...
Loading ...
Loading ...
32
ENGLISH
Intensive Cleaning of Water Bucket
Filters
1
Dissolve baking soda in water and soak the water
bucket lters in the solution for 30 minutes.
• Use 6 ½ tbsp. (100 g) baking soda in 2 ½ gal. (10 L)
water.
10L60L
10L (2 ½ gal.)
100 g
(6 ½ tablespoons)
2
Scrub the water bucket lters with a toothbrush or soft
brush to remove any foreign objects.
3
Thoroughly rinse the lters to remove any baking soda
residue.
4
If the lters are to be used immediately, shake off
excess water and reassemble. If storing the product
or not using it immediately, place the lters in a sunny
spot and allow to dry completely.
Caution
• If any detergent residue remains on the lter, it may
cause sudsing or odor during operation.
• Use of neutral detergent may result in severe sudsing.
For this reason, baking soda is preferred.
Assembling Water Bucket
After cleaning or lling the water bucket, reassemble it as
follows:
1
Mount the water bucket lters in the water bucket.
• First place the side lter in the bucket, then the top
lter, aligning the arrow on the lter with the arrow
on the water bucket.
• If the lters do not mount easily in the bucket, lift
and realign them until they lower easily into place.
2
Use the handle to carefully lower the water bucket into
the body of the product.
• Make sure the bucket is aligned so that the contact
connectors on the body slide through the slot in the
top of the bucket.
Loading ...
Loading ...
Loading ...