Loading ...
Loading ...
Loading ...
430 MULTIMEDIA
Headphones Operation
The headphones receive two separate channels
of audio using an infrared transmitter from the
video screen.
If no audio is heard after increasing the volume
control, verify that the screen is turned on, the
channel is not muted, and the headphone
channel selector switch is on the desired
channel. If audio is still not heard, check that
fully charged batteries are installed in the head-
phones.
Rear Seat Entertainment Headphones
Controls
The headphone power indicator and controls
are located on the right ear cup.
NOTE:
The rear video system must be turned on before
sound can be heard from the headphones. To
conserve battery life, the headphones will auto-
matically turn off approximately three minutes
after the rear video system is turned off.
Changing the Audio Mode for Headphones
1. Ensure the Remote Control channel/
screen selector switch is in the same posi-
tion as the headphone selector switch.
NOTE:
When both the headphone and the
remote control channel selector switches
are on Channel 1, the Remote is
controlling Channel 1 and the head-
phones are tuned to the audio on
Channel 1.
When both the headphone and the
remote control channel selector switches
are on Channel 2, the Remote is
controlling Channel 2 and the head-
phones are tuned to the audio on
Channel 2.
2. Push the SOURCE button on the remote
control.
3. Pushing the SOURCE button will advance to
the next mode.
4. When the Mode Selection menu appears on
screen, use the cursor buttons on the
remote control to navigate to the available
modes and push the OK button to select the
new mode.
5. To cancel out of the Mode Selection menu,
push the BACK button on the remote
control.
1 — Power Button
2 — Volume Control
3 — Channel Selection Switch
20_WD_OM_EN_USC_t.book Page 430
Loading ...
Loading ...
Loading ...