Loading ...
Loading ...
Loading ...
36 GETTING TO KNOW YOUR VEHICLE
The memory seat switch is located on the
driver’s door trim panel. The switch consists of
three buttons:
The set (S) button, which is used to activate
the memory save function.
The (1) and (2) buttons which are used to
recall either of two pre-programmed memory
profiles.
Memory Seat Buttons
Programming The Memory Feature
NOTE:
To create a new memory profile, perform the
following:
1. Place the vehicle’s ignition in the ON/RUN
position (do not start the engine).
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, power tilt
and telescopic steering column [if
equipped], and radio station presets).
3. Push and release the set (S) button on the
memory switch.
4. Within five seconds, push and release
either of the memory buttons (1) or (2). The
instrument cluster display will display which
memory position has been set.
NOTE:
Memory profiles can be set without the
vehicle in PARK, but the vehicle must be in
PARK to recall a memory profile.
To set a memory profile to your key fob, refer
to “Linking And Unlinking The Remote
Keyless Entry Key Fob To Memory” in this
section.
Linking And Unlinking The Remote Keyless
Entry Key Fob To Memory
Your key fobs can be programmed to recall one
of two pre-programmed memory profiles by
pushing the unlock button on the key fob.
NOTE:
Before programming your key fobs you must
select the “Memory Linked To Fob” feature
through the Uconnect system screen. Refer to
“Uconnect Settings” in “Multimedia” for further
information.
To program your key fobs, perform the following:
1. Place the ignition in the OFF position.
2. Select a desired memory profile, 1 or 2.
NOTE:
If a memory profile has not already been set,
refer to "Programming The Memory Feature" in
this section for instructions on how to set a
memory profile.
3. Once the profile has been recalled, push
and release the set (S) button on the
memory switch.
4. Within five seconds, push and release
button (1) or (2) accordingly. “Memory
Profile Set” (1 or 2) will display in the instru-
ment cluster.
5. Push and release the lock button on the key
fob within 10 seconds.
20_WD_OM_EN_USC_t.book Page 36
Loading ...
Loading ...
Loading ...