Loading ...
Loading ...
Loading ...
Wall Sleeve Brands:
#8 White-Westinghouse/Frigidaire/ 16" + 17',_" Deep
Carrier (52F Series)
1. If the wall sleeve does not have a rear grille or Iouvered panel, install
the plastic grille panel from the kit. The plastic grille panel is mounted
to the inside of the wall sleeve at the rear flanges. There are (4)
plastic nuts in the flanges of the wall sleeve. If your sleeve is missing
these nuts or they are damaged. Replacement nuts and grille
mounting screws are supplied with the kit. The nuts are installed
from the inside of the sleeve and are pressed into the square holes
of the rear flanges. Place the grille against the rear flanges and use
the (4) washer screws to secure the grille to the sleeve.
2. Cut and attach the (1) 1½" x 3/8 - x 26½" long seal to 25½" long.
Attach (2) 1½" x 3/8" x 14" long seals as shown. To attach the seals
remove the backing paper from the seal. Do not touch adhesive.
Press seals firmly in place.
3. Attach 1 .x 3/4" x 14" long seal to the inside of the grille panel as
shown in the illustration,
4. Install the new unit into the wall sleeve.
Attach the ground wire to the unit as shown.
5. Install the 1 "x 1½" x 84" long stuffer seal between the wall sleeve
and the unit. A flat bladed screwdriver or putty knife is recommended.
6. Assemble and install the Trim Frame. (see Trim Frame)
9
Loading ...
Loading ...