Loading ...
Wall Sleeve Brands:
#1 Emerson 15" Deep
ar_._ 10-1/4'
TOpView
1. Redirect the louvers at the back of the wall sleeve as shown in the
illustration. The use of pliers is recommended.
2, Attach (1) 1½"x 3/8"x 26'/_- long seal as shown in the illustration.
3, Attach the (2) 1½" x 3/8" x 14" long seals, to the inside of the
Iouvered pane. Install the seals as shown in the illustration,
4, Cut the 1½" x 3/8 "x 26'_" long seal to 14" long. and attach it to the
inside of the Iouvered panel as shown in the illustration. Attach the
(2) 4½" x 3½" x 1½" Centering/Support Blocks, one on each side wall,
to the inside of the sleeve with the Tappered End facing the opening.
These (2) blocks should be Iocaed approximately in the center of the
side walls. To attach the blocks remove the backing paper from the
blocks. Do not touch adhesive on the blocks. Press the blocks firmly
in place.
5. Install the new unit into the wall sleeve.
6. Attach the ground wire to the unit as shown.
7. Install the 1"x 1½, x 84" long stuffer seal between the wall sleeve
and the unit. A fiat bladed screwdriver or putty knife is recommended.
8. Assemble and install the Trim Frame. (see Trim Frame)
2
Loading ...
Loading ...
Loading ...