Loading ...
Loading ...
Wall Sleeve Brands: #2 Fedders 19¾"Deep
Rear Louvers
Top _rN_w
1. Redirect the louvers at the back of the wall sleeve as shown in the
illustration,The use of pliers is recommended.
2. Attach the (2) 4'½"x 3½"x 1½" Centering/Support Blocks to the inside
of the wails of the wall sleeve as illustrate with tapered end facing
the opening of sleeve. These (2) blocks should be located
approximately in the center of the side walls. To attach the blocks
remove the backing paper from the blocks. Do not touch adhesive on
the blocks. Press the blocks firmly in place.
3. Cut (2) 17"Tapered Spacer Blocks and install as shown in the
illustration. The 4" portion to be placed in front of the rib on base end
tapered end facing the back of _he slee_{e.The re_ai_ing portion to
be placed behind the rib. _ / _, " _
4. A_ach (1) 1½"x 1½"x 26½"long seals and the (2) 1½"x 1½"x 14"
long seals as shown in the illustration.
5. Cut (1) 1½' x 1',_"x 26_,_"long seal to 14" and attach to inside of the
Iouvered panel as shown in the illustration.
6. Install the new unit into the wall sleeve.
7. Attach the ground wire to the unit as
shown.
8. Install the 1 "x 1½"x 84" long stuffer seal between the wall sleeve
and the unit. A flat bladed screwdriver or putty knife is recommended.
9. Assemble and install the Trim Frame.
(see Trim Frame)
Loading ...
Loading ...
Loading ...