Loading ...
Loading ...
Loading ...
LOWER/UPPER THREADING
Getting Ready
29
1
Upper Threading
This section describes how to thread the machine and
the needle. The machine is marked with numbers that
indicate the threading order.
a
Turn on the machine.
b
Press the “Presser Foot Lifter” button to raise
the presser foot.
→ The upper thread shutter opens so the machine can
be threaded.
a Upper thread shutter
c
Press the “Needle Position” button to raise
the needle.
d
Pivot the spool pin so that it angles upward,
and then place the spool of thread on the
spool pin.
* Make sure that the thread unwinds from the front.
a
Spool cap
b Thread spool
c Spool pin
e
Slide the spool cap as far as possible onto the
spool pin, and then return the spool pin to its
original position.
CAUTION
• Be sure to thread the machine properly. Improper
threading can cause the thread to tangle and break
the needle, leading to injury.
• When using accessories not included with this
machine, attach the accessory to the machine after
threading the machine.
Memo
This machine is equipped with an upper thread
shutter, allowing you to check that the upper threading
is performed correctly.
7
8
10
11
12,13
9
14,15
2,16
3
1
4, 5
6
a
Note
If you try to thread the needle with the needle threader
lever without raising it, damage to the machine may
result.
CAUTION
• If the thread spool and/or spool cap are set
incorrectly, the thread may tangle on the spool pin
and cause the needle to break.
• Use the spool cap (large, medium, or small) that is
closest in size to the thread spool. If a spool cap
smaller than the thread spool is used, the thread may
become caught in the slit on the end of the spool and
cause the needle to break.
a
b
c
Loading ...
Loading ...
Loading ...