Loading ...
Loading ...
Loading ...
21
Rollers
Adjustable rollers behind the base grille enable
you to move the refrigerator away from the wall
for cleaning. These rollers should be set so the
refrigerator rests firmly on the floor. To assure
that the doors will close automatically from a
half-way-open position, there is a built-in tilt
from the front to the back of the cabinet. Side-
by-side refrigerators also have specially
designed door hinges that lift both doors
slightly when opened, allowing the force of
gravity to help close them securely.
Leveling
To adjust rollers, remove the base grille by
grasping it at the bottom and pulling it out.
Turn the roller adjusting screws clockwise to
raise the refrigerator, counterclockwise to lower
it. Use an adjustable wrench (3/8″ hex head
bolt) or pliers.
When leveling, you can improve door closure by
raising the front approximately 5/8″ (15 mm)
from the floor.
To replace base grille, align prongs on back of
grille with clamps in cabinet and push forward
until grille snaps into place.
Water
supply to
icemaker
(on some
models)
If your refrigerator has an icemaker, or if you
plan to add an icemaker later, the icemaker
will have to be connected to a cold water line.
A water supply kit containing copper tubing,
shutoff valve, fittings and instructions is
available at extra cost from your dealer.
There should be sufficient tubing for the
icemaker from the cold water supply to allow
you to move the refrigerator out from the wall
several feet [approximately 8 feet (244 cm) of
1/4″ copper tubing in three 10-inch (25 cm)
diameter coils].
Loading ...
Loading ...
Loading ...