Loading ...
Loading ...
Loading ...
Operation
Assist systems submenu
Assist
systems
menu
Function
Lane As-
sist*
Switching the Lane Assist system on or off
››› page 168.
Tiredness
detection*
Switching the tiredness detection on or off
(pause recommendation) ››› page 172.
Driving data
Presets
The MFD (multifunction display) shows differ-
ent values for the journey and the consump-
tion.
Changing between display modes on the
MFD
●
In vehicles without multifunction steering
wheel:
Press the rocker switch
on the
windscreen wiper lever
›››
Fig. 87
.
●
V
ehicle
s with a multifunction steering
wheel: turn the thumbwheel ››› Fig. 88.
Multifunction display memory
The multifunction display is equipped with
three memories that work automatically: MFD
from departure, MFD from refuelling, MFD to-
tal calculation. On the screen display, you
can read which memory is currently dis-
played.
To change between memories with the igni-
tion on and the memory shown, press the
button
on the windscreen wiper lever
or you can also change between memories
using the button
on the multifunction
steering wheel.
Menu Function
MFD from
depar-
ture
Display and storage of the values for the
journey and the consumption from when the
ignition is switched on to when it is switch-
ed off.
If the journey is continued in less than 2
hours after the ignition is switched off, the
new data is added to the data already stor-
ed in the memory. The memory will auto-
matically be deleted if the journey is inter-
rupted for more than 2 hours.
MFD from
refuelling
Display and storage of the values for the
journey and the consumption. By refuelling,
the memory will be erased automatically.
MFD total
calcula-
tion
The memory records the values for a specif-
ic number of partial trips, up to a total of 19
hours and 59 minutes or 99 hours and 59
minutes, or 1999.9 km or 9999 km, de-
pending on the model of instrument panel.
On reaching either of these limits
a)
, the
memory is automatically erased and starts
to count from 0 again.
a)
It varies according to the type of instrument panel fitted.
Erasing a memory manually
●
Select the memory that you wish to erase.
●
Hold the
button of the multifunction
steering wheel or the
button of the multi-
function wheel pressed down for about 2 sec-
onds.
Personalising the displays
In the Easy Connect system you can adjust
which of the possible displays of the MFD can
be shown on the instrument panel display
with the button
and the function button
Setup
››› page 81
.
Dat
a s
ummary
Menu Function
Current fuel
consumption
The current fuel consumption display
operates throughout the journey, in li-
tres/100 km; and with the engine run-
ning and the vehicle stopped, in li-
tres/hour.
Average fuel
consumption
a)
After turning on the ignition, average
fuel consumption in litres/100 km will
be displayed after travelling about 100
metres. Otherwise horizontal lines are
displayed. The value shown is updated
approximately every 5 seconds.
ACT
®
*: Depending on the equipment,
number of active cylinders.
76
Loading ...
Loading ...
Loading ...