Loading ...
Loading ...
Loading ...
7
This model may be installed as a free-standing unit (see clearance dimensions
below). However, for built-in installation, you must provide the following clearances
around the unit for best operation and proper ventilation: 3/16” on both sides, 2” at the
rear and 1/16” at the top. Take care that the air vent at the front of the keg beer
dispenser is never covered or blocked in any way.
Free-standing Installation (Model SBC678OS)
For freestanding installation, 5 inches (127mm) of space at the back and sides of the
unit are suggested, which allows the proper air circulation to cool the compressor and
condenser for energy saving. Air vents should never be blocked.
Keg Installation
Caster Guide
NOTE: Only model SBC678OS is supplied with casters.
(for use as a freestanding or outdoor beer dispenser)
• Install the four casters (2 locking casters at front) into the unit’s bottom (four screw
holes pre-supplied). Figure 1: before installation. Figure 2: casters installed.
CASTERS
Loading ...
Loading ...
Loading ...