Loading ...
Loading ...
Loading ...
23
English
Problem Action
The shaving sensor
responds even though the
shaver is not in contact
with the skin.
Clean the beard trimmings from
the shaver.
When the shaver is extremely
dirty, remove the foil frame and
wash with water.
(See page 17.)
Replace the system outer foil and/
or inner blades.
Expected life of system outer foil
and inner blades:
System outer foil:
Approximately 1 year
Inner blades:
Approximately 2 years
►When the STATUS lamp of the self-cleaning
recharger glows
It will light up for approximately 5 seconds every time the SELECT
button is pressed.
Problem Action
It is time to replace
the cleaning liquid.
Pour new water
and detergent into
the cleaning liquid
unit.
The “AUTO”
mode cannot be
used. The
“Charge” and
“Dry/Charge”
modes can be
used.
The cleaning liquid
unit is not properly
attached.
Properly attach the
cleaning liquid unit.
The self‑cleaning
recharger is tilted.
Place the self‑
cleaning recharger
on a horizontal
surface.
Problem Action
Use the self‑
cleaning recharger
outside the range of
the recommended
usage temperature.
Use the self‑
cleaning recharger
in temperature
15 °C (59 °F) or
higher.
Only “Charge”
mode can be
used.
After performing the above operation, press the SELECT button
and select a mode.
►When all self-cleaning recharger’s lamps blink
Problem Action
Appliance failure
Contact an authorized service
center.
FAQ
Question Answer
Why does “Dry/Charge”
mode take longer than
“AUTO” mode?
The drying time for the “Dry/
Charge” mode is set longer as
there may still be excess moisture
on the grip or areas other than the
system outer foil after the shaver
has been rinsed and cleaned with
water.
On the other hand, the drying
time for the “AUTO” mode is
shorter since only the system
outer foil is wet, which reduces
the total time for the whole mode.
ES-LT7N_US.indb 23 2015/04/17 17:45:29
Loading ...
Loading ...
Loading ...