Loading ...
Loading ...
Loading ...
ActionPossible causesProblem
If you want the dishwashing program to continue,
press Start/Stop and close the door within four
seconds.
The dishwasher door has been opened while a
program is in progress.
"Program paused" is shown on the display.
If you want to cancel the dishwashing program,
press and hold Start/Stop for three seconds.
Clean the coarse and fine filters.The filters are blocked.Water remains in the dishwasher above the filters.
Check that the filter handle is locked in the stop
position. The handle should point straight out
from the dishwasher.
The filters are not fitted correctly.
Clean the drain pump. See the chapter Care and
maintenance instructions.
Debris in the drain pump.
Check that the colored stop on the right in the
bottom drain is in place. See the chapter Care
and maintenance instructions.
Drain pump stop missing.
Check that the hose is free from kinks and sharp
bends.
Kink in drain hose.
Loosen the drain hose from where it terminates.
Check that no debris has clogged the hose. Is
the cone-shaped part of the drain boot cut to the
maximum size of the fitting where it attaches?
Blocked drain hose.
Clean with dish brush and low foaming cleaner.Dirt around the seals and in corners.Bad odor in dishwasher.
Run a program with a higher temperature once
or twice a month. Or run a self-cleaning program.
See Self-cleaning in the chapter Using the
dishwasher.
Low temperature programs have been selected
for a prolonged period.
Cleaning the garbage disposer connected to the
dishwasher can eliminate odors. Follow the
disposer manufacturer's cleaning instructions.
The dishwasher is connected to a garbage
disposer.
Activate the Extra Dry option.Depending on the load, the program's drying
cycle may be insufficient.
The dishes are not dry enough.
Fully load the dishwasher.The dishwasher is not fully loaded.
Top up with rinse aid or increase the rinse aid
dosage level. See the chapter Settings.
Rinse aid needs topping up or dosage is set too
low.
Switch all-in-one detergents or deactivate the
TAB setting and top up with salt and separate
rinse aid. See Rinse aid in the chapter Settings.
The TAB setting is activated and all-in-one
detergent with insufficient drying effect is being
used.
Open the door a little once the program has
finished.
19
Loading ...
Loading ...
Loading ...