Loading ...
Loading ...
Loading ...
12
Installation Cont.
• Drill 4 holes of Ø8mm on the wall, as illustrated below (Fig. 11).
• Hammer the wall plugs into the holes, then insert two ST4x30mm screws into the lower wall plugs. Tighten
the screws, but leave a 2mm gap so that you can hang the rangehood on the screws in the keyhole slots.
• Hang the hood to the wall screws, and make sure the hood is in balance and positioned correctly.
• Take away the Aluminum Filters, mark and drill another 2 holes of Ø8mm on the wall . (Safety Screw Holes)
• Take back the hood and hammer the wall plugs, hang the hood again and x the hood with two
ST4x30mm screws.
WARNING: Failure to install the screws or xing device in accordance with these instructions may result in
electrical hazards!
Fig. 11
Top-mounting in a cabinet
• Determine where in the top cabinet you want to install the rangehood, then drill 4 holes of Ø4mm at the
bottom of the hanging board of your cabinet (Fig. 12).
Fig. 12
30.5mm
215mm
450mm
Loading ...
Loading ...
Loading ...