Loading ...
©2017 Spectrum Brands, Inc.
Mastercode
Programming timeout: If the screen is not pressed for 20 seconds, the system will time out
(indicated by three beeps and the “X” pattern ashing three times), and you will need to restart the procedure.
1. Keep door open. Press and HOLD the
Program button until the Checkmark
symbol illuminates (about 5 seconds).
2. Press Checkmark symbol once. 3. Enter new Mastercode.
Using a Mastercode is an optional, added-security measure. It is not enabled by default. A Mastercode is
used to add and delete user codes, but it cannot unlock the door (unless the same code is programmed
as a user code, though this is not recommended). The Mastercode must be 4-8 digits.
4. Press Lock symbol once. 5. Re-enter Mastercode. 6. Press Lock symbol once.
If programming is successful, the Checkmark
will illuminate and you will hear one beep.
If programming is unsuccessful, the “X” pattern
will ash three times, and you will hear three
beeps. Make sure the Mastercode has not already
been programmed. Attempt the procedure again,
making sure to enter the same new Mastercode
in step 3 and 5.
Make sure switch #3 is on, and press the
Program button once. If you immediately
hear ve beeps and see the Checkmark ash
ve times, the Mastercode is enabled.
66852 / 01
954
2 / 16
Technical Support
1-866-863-6584
www.kwikset.com
1
A
B
About the Mastercode
Enabling and Setting the Mastercode
Loading ...
Loading ...
Loading ...