Loading ...
Loading ...
Loading ...
33
CARE AND CLEANING
ENGLISH
Oven Air Vents
Air openings are located at the rear of the cooktop, at the top
and bottom of the oven door, and at the bottom of the range.
Oven Door
y
Use soapy water to thoroughly clean the oven door.
Rinse well.
DO NOT
immerse the door in water.
y
You may use a glass cleaner on the outside glass of the
oven door.
DO NOT
spray water or glass cleaner on the
door vents.
y
DO NOT
use oven cleaners, cleaning powders, or harsh
abrasive cleaning materials on the outside of the oven
door.
y
DO NOT
clean the oven door gasket. The oven door
gasket is made of a woven material that is essential for
a good seal. Care should be taken not to rub, damage,
or remove this gasket.
NOTE
Do not use cleaners or harsh abrasive cleaning materials
on the outside of the oven door. Doing so can cause
damage.
NOTE
You may notice a "rainbow" effect on the oven door. This
is normal. The glass has been treated with a coating to
reflect heat for greater thermal efficiency, much like the
windows in your home.
Do not hand clean
oven door gasket
Remove any
debris from door
Control Panel
To prevent activating the control panel during cleaning,
unplug the range. Clean up splatters with a damp cloth using
a glass cleaner. Remove heavier soil with warm, soapy water.
Do not use abrasives of any kind.
LRG3085/LRG3083/
LSRG307
LRG3081 / LRG3091
LRG3021
NOTE
Do not block the vents and air openings of the range.
They provide the air inlet and outlet that are necessary for
the range to operate properly with correct combustion.
NOTE
To prevent scratching, do not use abrasive cleaners on any
of these materials.
Front Manifold Panel and Knobs
It is best to clean the manifold panel after each use of the
oven. For cleaning, use a damp cloth and mild soapy water or
a 50/50 solution of vinegar and water. For rinsing, use clean
water and polish dry with a soft cloth.
NOTE
y
Do not use abrasive cleansers, strong liquid cleaners,
plastic scouring pads or oven cleaners on the manifold
panel. Doing so will damage the finish.
y
Do not try to bend the knobs by pulling them up or
down or by hanging a towel or other objects on them.
This can damage the gas valve shaft.
y
The control knobs may be removed for easy cleaning.
y
To clean the knobs, make sure that they are in the “OFF”
position and pull them straight off the stems.
y
To replace the knobs, make sure the knob has the “OFF”
position centered at the top, and slide the knob directly
onto the stem.
Loading ...
Loading ...
Loading ...