Loading ...
Loading ...
Loading ...
Operation
WARNING
Incorrect use of the headlights may cause
accidents and serious injury, as the main
beam may distract or dazzl
e other drivers.
Note
●
If the turn signal l
ever is left on after the
key has been taken out of the ignition lock,
an acoustic signal sounds when the driver
door is opened. This is intended as a re-
minder to switch off the turn signal, unless
you wish to leave the parking light on.
●
If the convenience turn signals are oper-
ating (three flashes) and the other conven-
ience turn signals are switched on, the ac-
tive part stops flashing and only flashes
once in the new part selected.
●
The turn signal only works when the igni-
tion is switched on. The hazard warning
lights also work when the ignition is switch-
ed off.
●
If a trailer turn signal malfunctions, the
control lamp will stop flashing (trailer turn
signals) and the vehicle turn signal will
flash at double speed.
●
The main beam headlights can only be
switched on if the dipped beam headlights
are already on.
●
In cold or damp weather conditions, the
headlights, tail lights and turn signals may
mist up inside temporarily. This is normal
and in no way effects the useful life of the
vehicle lighting system.
●
The parking light does not activat
e auto-
matically if the left- or right-hand turn sig-
nal is left on and the ignition is disconnec-
ted.
Fog lights with cornering light func-
tion*
3 Not available on vehicles equipped with full-
LED headlights and bulb f
og lights.
The cornering light function is an additional
function to the dipped beam headlights to
improve lighting of the side of the road when
taking a sharp turn at low speed.
The cornering light function works when the
dipped beam headlights are already on and
it is activated when driving at speeds below
approximately 40 km/h (25 mph).
●
If the steering wheel is turned or the turn
signal is swit
ched on, the front fog light grad-
ually turns on. After the turn, the cornering
light function is gradually switched off.
●
When engaging reverse gear, both front fog
lights turn on.
“Coming home” and “Leav-
ing home” function
The “Coming home” and “Leaving home”
function lights up the vehicl
e’s immediate
proximity when getting into and out of it in the
dark. When switched on, the front position
and dipped beam lights, tail lights and li-
cense plate light come on.
The “Leaving Home” is controlled by a photo-
sensor.
In the vehicle settings menu of the infotain-
ment system you can adjust the duration of
the light switch-off delay, and activate and
deactivate the function.
Activating the “Coming Home” function
For vehicles with light and rain sensors.
●
Switch off the engine and remove the key
from the ignition with the light s
witch in posi-
tion
›››
page 115.
●
The automatic “Coming Home” function is
only active when the light sensor detects
darkness.
For vehicles without light and rain sensors.
●
Switch the ignition off.
●
Activate the headlight flashers for approxi-
mately 1 second.
When the driver door is opened, the “Coming
Home” lighting comes on. The delay in
118
Loading ...
Loading ...
Loading ...