Loading ...
Loading ...
Loading ...
Environment
- Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an ofcial collection point for
recycling. By doing this, you help to preserve the environment.
Guarantee & service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country. You nd its phone number in the worldwide
guarantee leaet. If there is no Consumer Care Centre in your country, go
to your local Philips dealer.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your country.
Problem Possible cause Solution
The ironing board
cover becomes
wet or there are
water droplets on
the garment during
ironing.
This may be caused by steam
condensing on the ironing board
cover after a long ironing session.
Replace the ironing board cover if the
foam material has worn out. You can
also add an extra layer of felt material
under the ironing board cover to prevent
condensation on the ironing board.
You can buy felt in a fabric shop.
It is likely that you have an ironing
board cover that is not designed to
cope with high steam rate of the
steam generator.
This felt material is also available on our
Philips online shop.
Water droplets
come out of the
soleplate.
The steam that was still present
in the hose has cooled down and
condensed into water. This causes
water droplets to come out of the
soleplate.
Steam away from the garment for a few
seconds.
Steam and/or water
comes out from the
EASY DE-CALC
knob.
The EASY DE-CALC knob is not
tightened properly.
Switch off the appliance and wait for two
hours for steam generator to cool down.
Unscrew EASY DE-CALC and screw it
back with proper alignment. Note: While
removing the knob, water will come out.
Dirty water and
impurities come out
of the soleplate or
the soleplate is dirty.
Impurities or chemicals present in
the water have deposited in the
steam vents and/or on the soleplate.
Clean the soleplate with a damp cloth.
ENGLISH 13
Loading ...
Loading ...
Loading ...