Loading ...
Loading ...
Loading ...
Installation
48
Side-by-side
The appliance has two side-wall heaters
encased in foam and can be installed
side-by-side with other appliances.
Each appliance must be installed in its
own niche.
Please contact your dealer for specific
information about which combinations
will work with your appliance.
WARNING! This appliance must
be built in, otherwise it could tip
over!
Install the appliance in accordance
with the installation instructions.
Fire hazard and risk of damage!
The appliance must not be installed
underneath a cooktop.
Installation location
This appliance should be installed in a
dry, well-ventilated room.
When deciding where to install your ap-
pliance, please bear in mind that the
energy consumption will increase if in-
stalled near to a heater, a cooker, or
other appliance that gives off heat. Di-
rect sunlight should also be avoided.
The higher the room temperature, the
longer the compressor has to run and
the higher the energy consumption is.
When installing the appliance, please
note:
– The electrical socket must be easily
accessible in an emergency and not
concealed behind the appliance.
– The plug and power cord must not
touch the back of the appliance as
they could be damaged by vibrations
from the appliance.
– Do not plug other appliances into
electrical sockets behind this appli-
ance.
In environments with high hu-
midity condensation may appear on
the external surfaces of the appli-
ance.
Condensate can cause corrosion on
external appliance walls.
For prevention, it is advisable to in-
stall the appliance with sufficient
ventilation in a dry and/or air condi-
tioned room.
After installation make sure that the
appliance door closes properly, the
air vents are not covered and that
the appliance has been installed in
accordance with these installation in-
structions.
Loading ...
Loading ...
Loading ...