Loading ...
Loading ...
Loading ...
Enhanced Accident Response
System Reset Procedure
After the event occurs, when the system
is active, a message regarding fuel cutoff
is displayed. Turn the ignition switch from
ignition AVV/START or MAR/ACC/ON/
RUN to ignition STOP/OFF/LOCK.
Carefully check the vehicle for fuel leaks
in the engine compartment and on the
ground near the engine compartment and
fuel tank before resetting the system and
starting the engine.
Depending on the nature of the event the
left and right turn signal lights, located in
the instrument panel, may both be
blinking and will continue to blink. In order
to move your vehicle to the side of the
road, you must follow the system reset
procedure.
Customer Action Customer Will See
Note:
Each step MUST BE held for at least two
seconds
1. Turn ignition
ST
OP/OFF/LOCK.
(Turn Signal Must be
placed in Neutral
State).
2. Turn ignition
MAR/ACC/ON/RUN.
Right turn light
BLINKS.
Left turn light is OFF.
Customer Action Customer Will See
Note:
Each step MUST BE held for at least two
seconds
3. Turn right turn
signal
switch ON.
Right turn light is ON
SOLID.
Left turn light
BLINKS.
4. Place turn signal in
neutral state.
Right turn light is
OFF.
Left turn light
BLINKS.
5. Turn left turn
signal switch ON.
Right turn light
BLINKS.
Left turn light is ON
SOLID.
6. Place turn signal in
neutral state.
Right turn light
BLINKS.
Left turn light is OFF.
7. Turn right turn
signal switch ON.
Right turn light is ON
SOLID.
Left turn light
BLINKS.
8. Place turn signal in
neutral state.
Right turn light is
OFF.
Left turn light
BLINKS.
9. Turn left turn
signal switch ON.
Right turn light is ON
SOLID.
Left turn light is ON
SOLID.
Customer Action Customer Will See
Note:
Each step MUST BE held for at least two
seconds
10. Turn left turn
signal
switch OFF.
(Turn Signal Switch
Must be placed in
Neutral State).
Right turn light is
OFF.
Left turn light is OFF.
11. Turn ignition
STOP/OFF/LOCK.
12. Turn ignition
MAR/ACC/ON/RUN.
(Entire sequence
needs to be
completed within
one minute or
sequence will need
to be repeated).
System is now reset
and the engine may
be started.
Turn hazard flashers
OFF (Manually).
If a reset procedure step is not
completed within 60 seconds, then the
turn signal lights will blink and the reset
procedure must be performed again in
order to be successful.
114
SAFETY
Loading ...
Loading ...
Loading ...