Loading ...
Loading ...
Loading ...
7
Bottom front of refrigerator
3
Adjustment and Anchoring
Adjust the tilt with the adjustable supports.
Caster
(To prevent vibration, noise,
movement, and doors left ajar)
Turn the adjustable supports to the floor and anchor
them so that the refrigerator will not move.
Right
Right
Left
Left
The right door tilts down The left door tilts down
Fully insert the adjustable support cover
horizontally until it touches the rear side.
Anchor the refrigerator
to a strong and level
floor by adjusting the
adjustable supports.
Otherwise, the refrigerator may
move and cause injury.
Follow the
instructions
Turn the adjustable supports in the
arrow direction until they touch the
floor.
Adjustable
support
cover
Adjustable
support
cover
Adjustable
support
Caster
Adjustable support
Turn the right adjustable support
in the direction of the arrow to
lower the refrigerator.
If the door is still tilted after
adjusting the adjustable support,
place a strong board*
1
under the
adjustable support on the left
rear side to make it level.
Turn the adjustable support in the direction of
the arrow to lower the refrigerator, and insert
a felt sheet between the support and the floor.
Insert the tool as far as it goes into the
indentation of the adjustable support.
Turn the tool to adjust the tilt of the refrigerator.
Turn the left adjustable support
in the direction of the arrow to
lower the refrigerator.
If the door is still tilted after
adjusting the adjustable support,
place a strong board*
1
under the
adjustable support on the right
rear side to make it level.
Adjust the supports to
make the refrigerator level.
If the front of the
refrigerator is slightly
raised, the doors are
easier to close.
If you find it difficult to turn the adjustable supports,
use the supplied adjustable support tool kit.
The adjustable support tool kit is stored inside the refrigerator compartment at shipment.
* The figure shows the left adjustable support as an example. The right adjustable support looks the same.
A few days after installation, the floor may sink due to the refrigerator's
weight. Readjust the tilt with the adjustable supports.
*
1
Normally, use a board with a thickness of 2 to 3 mm.
Adjustable support
(lower front
section)
Felt sheet
Adjustable support tool
Prepare for Earthquakes
It is recommended to
pass 2 strong belts
through the hand-holds
on the top rear of the
refrigerator and anchor
them to a strong location,
such as a wall or post.
Strong Belts
Prohibited
Use in hot spring and geothermal areas
Corrosion control treatment may be required for the refrigerant circuit
(pipe) due to generation of corrosive gases.
Contact the retail store where you purchased the refrigerator.
Do not damage the refrigerant circuit (pipes) or
drive screws into it.
Because combustible refrigerant is used, this may result in fire
or an explosion.
Indentation
After adjustment, attach the adjustable support cover.
(The adjustable support
cover is stored inside the
refrigerator compartment
at shipment)
Installation
Loading ...
Loading ...
Loading ...