Loading ...
Loading ...
Loading ...
Problem Cause Solution
I cannot insert the brew
group.
The brew group is not in the
correct position.
You did not put the brew
group in neutral position
before placing it back. Make
sure that the lever is in contact
with the base of the brew
group and that the hook of the
brew group is in the correct
position.
Reset the machine by turning
it on and o. Place the drip
tray and the coee grounds
container back. Leave the
brew group out. Close the
maintenance door and turn the
machine on and o. Then try
to reinsert the brew group.
The machine is still in the
descaling procedure.
You cannot remove the
brew group when the
descaling process is active.
First complete the descaling
process and then remove the
brew group.
The coee has too little
crema or is watery.
The grinder is set to a too coarse
setting.
Adjust the grinder to a ner
setting.
You are using an unsuitable
coee blend.
Start using a dierent coee
blend.
The machine is performing its
self-adjustment.
Brew a few cups of coee.
The brew group is dirty. Clean the brew group.
Coee is leaking from
the coee dispensing
spout.
The coee dispensing spout is
clogged.
Clean the coee dispensing
spout and its holes with a pipe
cleaner.
The coee is not hot
enough.
The cups you use are cold. Preheat the cups by rinsing
them with hot water.
The temperature is set too low.
Check the menu settings.
Set the temperature to 'high' in
the menu.
You added milk. Whether the milk you add
is warm or cold, it always
decreases the temperature of
the coee to some extent.
English
35
4219_460_3631_2_Lux_Booklet_A5_v2.indd 35 21/07/17 14:30
Loading ...
Loading ...
Loading ...