Loading ...
Loading ...
Loading ...
12
Troubleshooting
If you experience Possible Causes Solution
Water Leaks
Check the following
for proper installation Washer not level. Water may splash off basket if washer is not level. Check that
load is not unbalanced or tightly packed.
Fill-hoses not attached tightly. Tighten ll-hose connection.
Fill-hose washers. Make sure all four ll-hose at washers are properly seated.
Drain-hose connection. Pull drain hose from washer cabinet and properly secure
it to drainpipe or laundry tub.
Do not place tape over drain opening.
Check household plumbing for leaks
or clogged sink or drain. Water can back up out of a clogged sink or drainpipe. Check all
household plumbing for leaks (laundry tubs, drain pipe, water
pipes, and faucets).
Washer not loaded as
recommended. Improper loading can cause basket to be out of alignment
and cause water to splash off tub. See the “Using Your Washer”
section for loading instructions.
Washer Not Performing As Expected
Not enough water
in washer Load not completely covered
in water. This is normal operation for a high efciency washer. If the Water
Level knob is set to Auto Sensing, the load will not be completely
under water. The washer senses the load size and adds
the correct amount of water for optimal cleaning.
Turn the Water Level knob to Deep Water Wash to increase
the amount of water used to wash.
Run Clean Washer with affresh® cycle to optimize the water level
and wash performance due to soil buildup in washer basket.
Washer won’t run
or ll, washer stops
working, or wash light
remains on (indicating
that the washer was
unable to ll
appropriately)
Check for proper water supply. Both hoses must be attached and have water owing
to inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check inlet hoses for any kinks, which can restrict water ow.
First try the solutions suggested here, or visit our website at www.whirlpool.com/product_help
in Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
Washer won’t run
or ll, washer stops
working, or wash light
remains on (indicating
that the washer was
unable to ll
appropriately) (cont.)
Check proper electrical supply. Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Loading ...
Loading ...
Loading ...