Loading ...
Loading ...
Loading ...
11
REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to Installation Instructions to locate, level,
and connect washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water-inlet hoses.
Turn on both water faucets.
2. Plug in washer or reconnect power.
3. Run washer through Bulky Items/Sheets cycle to clean
washer and remove antifreeze if used. Use half
the manufacturer’s recommended amount of detergent
for a medium-size load.
Troubleshooting
If you experience Possible Causes Solution
Vibration or Off-Balance
Check the following for
proper installation or
see the “Using Your
Washer” section.
Feet may not be in contact with
the oor and locked. Front and rear feet must be in rm contact with oor, and washer
must be level to operate properly.
Washer may not be level. Check oor for exing or sagging. If ooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See the “Level the Washer” section in the
Installation Instructions.
Load could be unbalanced. Load dry items in loose heaps evenly around basket wall.
Adding wet items to washer or adding more water to basket
could unbalance washer.
Wash smaller loads to reduce imbalance.
Do not tightly pack. Avoid washing single items.
Use Bulky Items/Sheets cycle for oversized, non-absorbent
items such as jackets and small comforters. See the “Cycle
Guide” chart.
See the “Cycle Guide” chart and the “Using Your Washer” section.
Noises
Clicking or metallic
noises. Objects caught in washer
drain system. Empty pockets before washing. Loose items such as coins
could fall between basket and tub or may block pump.
It may be necessary to call for service to remove items.
It is normal to hear metal items on clothing such as snaps,
buckles, or zippers touch against the basket.
Gurgling or humming. Washer may be draining water. It is normal to hear the pump making a continuous humming
sound with periodic gurgling or surging as nal amounts of water
are removed during the Drain & Spin cycles.
Humming. Load sensing may be occurring. You may hear the hum of the sensing spins after you have
started the washer. This is normal.
Whirring. Basket deceleration may be
occurring. You may hear the whirring sound of the basket decelerating.
This is normal.
First try the solutions suggested here, or visit our website at www.whirlpool.com/product_help
in Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
TRANSPORTING YOUR WASHER (cont.)
6. Drape power cord over edge and into washer basket.
7. Place packing tray from original shipping materials back
inside washer. If you do not have packing tray, place heavy
blankets or towels into basket opening. Close lid and place
tape over lid and down front of washer. Keep lid taped until
washer is placed in new location. Transport washer
in upright position.
Loading ...
Loading ...
Loading ...