Loading ...
Loading ...
Loading ...
Air Conditioner Features
(continued)
I
FIG. 1 (OFF)
FIG.2 (FRESHAIR)
FIG.3 (VENT)
A slight heat odor may come from the unit when first switching to HEATafter
the cooling season is over. this odor, caused by fine dust particles on the
heater, will disappear quickly.
Vent Control
The Vent Control allows the air conditioner to either recirculate inside air
(CLOSED)or exhaust air to the outside (OPEN).
The CLOSEDposition is used when maximum cooling isdesired. It may also
be used for air recirculation without cooling when the air conditioner is set
in the FAN position.
The OPENposition removes stale air from the room and exhausts it to the
outside. Fresh air is drawn into the room through normal air passages
found in homes.
The OPENor CLOSEDposition can be used with any fan selection.
For compact models, push the slide in to CLOSE, pull out to OPEN.
Fresh Air Vent Control
The FreshAir Vent allows the air conditioner to recirculate inside air (OFF),
draw air into the room (FRESHAIR) or exhaust stale air to the outside (VENT).
See Figures 1,2 & 3 for this operation.
Air Directional Louvers
The air directional louvers control the air flow direction. Adjust louvers up,
down, left or right. The outside tabs adjust the air up or down. The center
levers direct the air left or right.
Care and Cleaning
Figure 1
Clean your air conditioner occasionally to keep it looking new. Be sure to unplug
the unit before cleaning to prevent shock or fire hazards.
Air Filter Cleaning
The air filter should be checked at least once a month to seeif cleaning is necessary.
Trapped particles in the filter canbuild up and causean accumulation of frost on the
cooling coils.Theseconditions reducecooling capacity. Thereare two types of filters:
the rigid filter and the floppy filter.
Models with rigid filters allow you to remove the filter without removing front:
Some models, push the vent control handle to the OFF position. Liftthe filter straight
up and out (Figure 1).
Loading ...
Loading ...
Loading ...