Loading ...
Loading ...
Loading ...
We recommend that you keep the
packaging and the transit bolts
for any transport of the appliance.
POSITIONING
Adjust the appliance correctly to prevent vibration,
noise and movement of the appliance when it
operates. Install the appliance on a flat hard floor.
The appliance must be levelled and stable. Make
sure that the appliance does not touch the wall or
other units and there is air circulation below the
appliance. Loosen or tighten the feet to adjust the
level. All feet must rest firmly on the floor.
WARNING! Do not put cardboard,
wood or equivalent materials below
the appliance feet to adjust the level.
WATER INLET
WARNING! This appliance must
be connected to a cold water
supply.
Before connecting up the
machine to new pipework or to
pipework that has not been used
for some time, run off a
reasonable amount of water to
flush out any debris that may
have collected in the pipes.
1. Connect the water inlet hose supplied with the
machine to a tap with a 3/4" thread. Always
use the hose supplied with the appliance.
Do not use the hose from your
previous machine to connect
to the water supply.
2. The machine end of the inlet hose can be
turned in any direction. Set the hose correctly
by loosening the ring nut. After positioning the
inlet hose, be sure to tighten the ring nut again
to prevent leaks.
WATER DRAINAGE
The end of the drain hose can be positioned in
three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine.
In this case, make sure the end cannot come
unhooked when the machine is emptying. This
6
Loading ...
Loading ...
Loading ...