Loading ...
Loading ...
Loading ...
22
Installation Instructions
ELECTRICAL CONNECTIONS (CONT.)
C
D
For conduit installations only, purchase a squeeze
connector matching the diameter of your conduit
and assemble it in the hole. Insert the conduit through
the squeeze connector and tighten. Allow enough
slack to easily attach the wires to the terminal block.
NOTE: Do not install the conduit without a squeeze
connector. The squeeze connector should be in-
stalled before reinstalling the rear range wiring cover.
For power cord installations only (see the next step if
using conduit), assemble the strain relief in the hole.
Insert the power cord through the strain relief and
tighten. Allow enough slack to easily attach the cord
terminals to the terminal block. If tabs are present at
the end of the winged strain relief, they can be re-
moved for better fit.
NOTE: Do not install the power cord without a strain re-
lief. The strain relief bracket should be installed before
reinstalling the rear range wiring cover.
Skip to Step 4 or 5.
Skip to Step 6 or 7.
3-WIRE POWER CORD INSTALLATION4
WARNING: The neutral or ground wire of
the power cord must be connected to
the neutral terminal located in the cen-
ter of the terminal block. The power
leads must be connected to the left
and the right terminals of the terminal
block.
A
Remove the 3 lower terminal screws from the termi-
nal block. Insert the 3 power cord terminal rings
into each one of the terminals of the terminal
block. Be certain that the center wire (white/neu-
tral) is connected to the center of the terminal
block. Tighten nuts securely into the terminal block.
DO NOT remove the ground strap connection.
B
Skip to Step 8 and proceed with the installation.
Loading ...
Loading ...
Loading ...