1. Home
  2. Gaggia
  3. Gaggia 886876203630 User Manual
  4. Page 29

User Manual - Page 29

For 886876203630.

Loading ...
Loading ...
Loading ...
23
ENGLISH
MAINTENANCE PRODUCTS
Product
• Descaling solution
• INTENZA+waterltercartridge
• Brew group grease
• Degreasing tablets
• Milk circuit cleaning system
• Maintenance kit
10.2 INTENZA+waterlter
ItisrecommendedtoinstalltheINTENZA+waterlterthatlimitslimescaleformation
inside the machine and improves the aroma of your coffee.
Waterisafundamentalcomponentofcoffeebrewing:thisiswhyitisessentialtolter
itprofessionally.TheINTENZA+waterltercanpreventtheformationofmineral
deposits and improve water quality. It is sold separately.
10.2.1 INTENZA+ installation
> Removethesmallwhitelterinthewatertankandstoreitinadryplace.
Filter setting phase
> RemovetheINTENZA+waterlterfromitspackaging,immerseitverticallyincold
water, with the opening upwards, and slightly press the sides to let air bubbles out.
Inordertousetheltercorrectly,itisnecessarytomeasurethewaterhardnessas
shown in the “5.3.1 Water hardness measurement and setting” chapter.
>
SettheINTENZA+waterlteraccordingtotheresultsofthetest,operatingonthe
lterbase:
Letteronthelter Water hardness Test strip squares
A soft water 1 - 2
B hard water (standard) 3
C very hard water 4
> InserttheINTENZA+waterlterintheemptywatertank.
>
Push it to the lowest possible point.
>
Fill the water tank with fresh water and restore it to the machine.
Dispense all the water contained in the tank as detailed in the “6.5.1 Hot water
dispensing” chapter.
>
Fill the water tank again.
Machine setting phase during the installation
> Press the MENU button,conrmbypressingtheOKbuttonand scroll the menu to go
tothe‘INTENZA+Filterfunction.’ThedefaultsettingisOFF(inactivelter).
>
Press the UP button to select the ON value.
>
PresstheOKbuttontoconrmthechange.
Themodiedbutunconrmedvalueswillnotbestored.
With the ON value the machine is programmed to inform the user that the
INTENZA+waterltermustbereplaced.
Once the INTENZA+lterhasbeenactivated,noiconappearsonthe
display.
>
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for 3
minutes. At the end, the machine goes back to the main menu.
10.2.2 INTENZA+ replacement
The‘INTENZA+waterltertobereplaced’signalisdisplayed.
Replace the INTENZA+ water lter as described in the “10.2.1 INTENZA+
installation” chapter, performing only the “Filter setting phase” section, and then
proceed as follows.
ON
OFF
FILTER
FILTER
Loading ...
Loading ...
Loading ...