Loading ...
Loading ...
Loading ...
19
ENGLISH
Ifsupplied,removethesmallwhitelterandreplaceitwiththeINTENZA+lter.
At the end, the machine goes back to the main menu. It is recommended to perform
a “5.2.3 Manual rinse cycle”.
7.5.1 Interruption of the descaling cycle
Once the descaling cycle has started, you must complete it till the very end without
turning off the machine.
> In case you get stuck during the cycle you can exit by pressing the STAND-BY button.
>
If this occurs, or in case of power failure or accidental disconnection of the power
cord,emptyandrinsecarefullythewatertank,thenllituptotheCALCCLEAN
level. Follow the instructions provided in the “5.2.3 Manual rinse cycle” chapter before
brewing any product. If the cycle was not completed, the machine will require another
descaling cycle to be performed at your earliest convenience.
8. Default settings
8.1 List of default settings
Display Setting Value Description
COFFEE
TEMP
MAX
MED
MIN
Coffee
temperature
average Coffee brewing temperature setting.
STANDBY
180’
60’
30’
15’
Stand-by time 15 minutes Stand-by time setting.
DISPLAY
CONTRAST
Contrast average Display contrast setting.
WATER
HARDNESS
4
3
2
1
Water hardness
4 (very hard
water)
Water hardness setting. For further details, please
refer to the “5.3.1 Water hardness measurement and
setting” chapter.
FILTER
WATER
FILTER
ON
OFF
FILTER
INTENZA+
waterlter
OFF (not
installed)
INTENZA+ settings. For further details, please refer
to the “10.2 INTENZA+ water lter” chapter.
8.2 Changing the default settings
It is possible to customise the machine functions through the programming menu. The
machine must be turned on and ready to work.
If necessary, refer to the “8.1 List of default settings” chapter.
>
Press the MENU button, conrm by pressing the OK button and scroll through
functionslisttoselectthefunctionwhosesettingsaretobemodied.
Note: the images at the side refer to a sample function.
>
Press the OK button to select the desired function.
Once selected:
>
Press the UP button to increase the value.
>
Press the DOWN button to decrease the value.
>
PresstheOKbuttontoconrmthechange.
When the change has been implemented, the OK message will be displayed.
Themodiedbutunconrmedvalueswillnotbestored.
>
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for 3 minutes.
8.3 Reset to the default settings
It is possible to restore the default settings through the programming menu. The
machine must be turned on and ready to work.
>
Press the MENU button, conrm by pressing the OK button and scroll through
functions list to select the RESET function.
>
Press the OK button to select the function.
When the change has been implemented, the OK message will be displayed.
START
CALC
CLEAN
DISPLAY
CONTRAST
RESET
Loading ...
Loading ...
Loading ...