Loading ...
Loading ...
Loading ...
6
EXTRA RINSE
This option can be used to automatically add a second
rinse to most cycles.
DEEP CLEAN + STEAM
The Deep Clean + Steam option adds additional soak and
wash time to many cycles to help remove tough stains,
as well as a steam boost for added cleaning power.
Deep Clean + Steam uses a heater within the washer to
maintain the selected temperature setting throughout the
wash period. Deep Clean + Steam may be selected as an
option with other cycles.
Note: The Deep Clean + Steam option may increase the
selected temperature.
DEEP FILL
If you would like to add the maximum amount of water to
your wash cycle, select the Deep Fill option.
NOTE: Expect longer cycle times due to extended fill
times when using the Deep Fill option.
CYCLE STATUS LIGHTS
The Cycle Status Lights show the progress of a cycle. At
each stage of the process, you may notice sounds or
pauses that are different from traditional washers.
DELAY
When Delay Start has been selected, the Delay light will
illuminate and remain illuminated until the cycle begins.
LID LOCKED
The Lid Locked feature allows for higher spin speeds.
When lit, the lid is locked and cannot be opened without
pausing the cycle. When the light is off, the lid can be
opened.
To open the lid after it has been locked, press START/
PAUSE. The lid will unlock once the washer movement
has stopped. This may take several minutes if the load
was spinning at high speed. Press START/PAUSE while
the lid is closed to resume the cycle.
SENSING
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the
motor turning on briey (short hum) to move the basket
while lling.
WASH
During the rst stage of the wash cycle, water will partially
ll the washer and begin to move the load. You will hear
the impeller rotate followed by a several second pause.
This process will repeat for several minutes, allowing
the entire load to become saturated. It is normal for the
load to be above the water line during this stage. At the
beginning of the second stage, the washer will add water
to the correct level based on the load size. You will hear
the impeller increase speed during this stage of the wash
cycle. The motor sounds may change at different stages
in the wash cycle.
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the
motor turning on briey (short hum) to move the basket
while lling.
SPIN
The washer spins the load at increasing speeds for
proper water removal based on the selected cycle and
spin speed.
DONE
Once the cycle is complete, this light will come on. For
best results, promptly remove the load.
7
Loading ...
Loading ...
Loading ...