Loading ...
Loading ...
Loading ...
5. Line up
front of
cover and
base° Rest
cover on
front edge of
base as
shown.
6, NOTE:
dirt sensor mod-
els be sure that
the board is
upright and the
wires are tucked
back as shown.,
7. Tilt cover to
back. Press cover
firmly until side
and rear tabs snap
into place, Turn
POWER-MATE TM
upside down and
replace two (2)
cover screws,
'1. Remove POWER-MATE TM cover as
shown in BELT CHANGING AND AGITA-
TOR CLEANING section.
Push In
And Turn
i__ 2. Push in and turn
bulb counterclock-
wise, then pull out
to remover
Push In
And Turn
3. Push in and turn
bulb clockwise, to
replace° Bulb must
not be higher than
130 Volts/15 Watts.
4. Reinstall POWER-MATE TM cover as
shown in BELT CHANGING AND AGITA-
TOR CLEANING section.
NOTE: Use bulb #20-5240. In Canada.
#596181.
18
Loading ...
Loading ...
Loading ...