Loading ...
Loading ...
Loading ...
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build-
up frequently in the POWER-MATE TM
agitator and end cap areas, If build-up
becomes excessive, disconnect POWER-
MATE TM from wand and follow the steps
below°
TO REMOVE BELT:
t
1. Turn POWER-
MATETM upside
down,
2. Unscrew the
two (2) POWER-
MATETM cover
screws,,
3, Turn POWER-
MATE TM right side
up. Press handle
release pedal and
lower the swivel
Lift rear latches up.,
4, To remove cover,
grasp the sides and
pull out.
5. Depress
tabs on rear of
agitator cover
and rotate
forward to
release from
the POWER-
MATETM base_
Agitator
Cover
6. Lilt agitator
assembly out
and remove
worn belt,
7. Slide end caps
off to check and
clean end cap
areas. See
AGITATOR
ASSEMBLY for
picture of complete
agitator assembly°
End Cap
TO REPLACE BELT:
'1. Slide washers
and end caps onto
agitator assembly,
2. Install new
belt over motor
drive, then
over brush
sprocket.
NOTE: Use
belt #20-5201
In Canada,
#20-40979°
C
e
3, Place agitator
assembly back into
POWER-MATE TM,
4. Reinstall
agitator
cover by lin-
ing up the
front tabs
and slots
and rotating
downward ,i
until the
latches
snap into place.
Agitator Cover
Tabs
EndCap
17
Loading ...
Loading ...
Loading ...