Loading ...
Loading ...
Loading ...
SOME MODELS
The dirt sensor light system is mounted on
the POWER-MATE TMnozzle near the reset
button. It consists of a series of three red
lights and one green light_
The lights give
you an indica-
tion of the
amount of dirt
particles that
are passing
thru the sensor
Dirt Sensor
(Some Models) on itsway to
the dust bag.
INITIAL START UP
When the POWER-MATE TMis first started,
the following sequences occurs in a two sec-
ond time frame:
1. All three reds come on.
2. Two reds are on.
3. One red is on.
4. One green is on and will remain on until
the POWER-MATE TMnozzle is placed in use.
NOTE: tf the nozzle is on a surface that has
dirt on it, dirt will be picked up by the vacuum
and one or more red lights might stay on.
IN OPERATION
When the POWER-MATE TMis being moved
back and forth on the floor, the lights will
change from one configuration to another as
more dirt or less dirt is being vacuumed. As
long as one or more red lights are on, dirt is
passing through the wand to indicate that the
surface still needs cleaning_
When the green light stays on as the
POWER-MATE TMis moved back and forth
over an area, the sensor is not seeing
enough dirt to warrant further cleaning of that
area,
NOTE: Dirt sensor lights DO NOT function in
the FLOOR setting.
CLEANING LENS
Although the dirt sensor feature in your
Kenmore POWER-MATE TMis designed for
years of trouble free use, the passage of dirt
through the air passage system can coat the
lens causing the green light to come on and
stay on - never switching to red. When this
happens the lens must be cleaned_
10
TO CLEAN THE LENSES:
1. Remove the
wands by press-
ing the quick
release pedal and
liftingup on the
wands.
Cross Section View
f
Approx.,
3 ½ inches
or 90 mm
Sensor
Elements
2. As indicated by the illustration, the two dirt
sensor elements are located on the inside of
the swivel, approximately 3½ inches/90 mm
down, (note the arrows). Each element
should be cleaned periodically° To reach the
sensor elements, use a small brush such as
a bottle brush. Brush each sensor element
several times to remove dust and dirt.
NOTE: Looking down inside the swivel you
will see a dng. The sensor elements are
located just slightly below this ring.
3. Reinstallthe wands after cleaning the sen-
sors.
Never use water or any cleaning
solution when cleaning the lenses.
The residue of the water or cleaners
will accelerate the recoating of the
lenses and make cleaning necessary
sooner.
i iiii iiii
Loading ...
Loading ...
Loading ...