Loading ...
Loading ...
Loading ...
Care and Cleaning
www.geadvantium.com
1. To replace the cooktop light/
night light, first disconnect the
power at the main fuse or circuit
breaker panel.
2. Remove the screw from the
side of the light compartment
cover and lower the cover until
it stops.
3. Be sure the bulb to be replaced is
cool before removing. Gently pull
the bulb from the receptacle.
Replace with 20-watt (max.) 12 volt
halogen bulb. Order WB36X10176 from
your GE supplier. High-intensity 20-watt
bulbs, available in supermarkets and
hardware stores, may also be used for
replacements.
4. Raise the light cover and replace
the screw. Connect electrical
power to the oven.
Remove screw
Cooktop light/
night light
The metal filters trap grease released
by foods on the cooktop. They also
prevent flames from foods on the
cooktop from damaging the inside
of the oven.
For this reason, the filters must
always be in place when the hood
is used. The vent filters should be
cleaned once a month, or as needed.
To remove, slide them to the rear
using the tabs. Pull down and out.
To clean the vent filters, soak them
and then swish around in hot water
and detergent. Don’t use ammonia
or ammonia products because
they will darken the metal. Light
brushing can be used to remove
embedded dirt.
Rinse, shake and let dry before
replacing.
To replace, slide the filters into the
frame slots on the back of each
opening. Press up and to the front
to lock into place.
Reusable vent
filters
Removing and
cleaning the
filters
41
Loading ...
Loading ...
Loading ...