Loading ...
Loading ...
Loading ...
• 14 •
• Make sure that the lever is in contact
with the brew group. Press the “PUSH”
button to make sure that the brew
group is in the correct position.
Lubricate the brew group
after approximately 500
brewing cycles. The brew group
lubricant may be purchased through
Saeco or authorized service centers.
• Lubricate the brew group guides using
the supplied lubricant only.
• Apply the lubricant evenly on both side
guides.
• Insert the brew group in its seat until it
locks into place WITHOUT pressing the
“PUSH” button.
• Insert the dregdrawer. Close the service
door.
Warning! Never drink the
descaling solution or any pro-
ducts dispensed until the cycle has
been carried out to the end. Never
use vinegar as a descaling solution.
Before descaling, remove the Pannarello
(if supplied) from the steam wand as de-
scribed in the “Cleaning and Maintenance”
section.
• Turn the machine on by pressing the
ON/OFF button. Wait for the machine
to finish its rinse and warm-up
process.
MAX
MIN
MAX
MIN
DESCALING
Limescale normally builds up with the
use of the appliance. The machine needs
descaling every 1 - 2 months or whenever
a reduction in water ow is noticed.
In case of conflict, priority
must be given to what is
indicated in the operation and main-
tenance manual over the instructions
provided on separately sold accesso-
ries and materials.
Use the Saeco descaling pro-
duct. Its formula has been
designed to ensure better machine
performance and operation for its
whole operating life. If correctly used,
it also avoids alterations in the brewed
product.
Do not turn the machine o or
put it in stand-by mode during
the descaling process.
Warning! Remove the “Inten-
za” filter before adding the
descaling solution.
• Pour the entire content of the Saeco
concentrated descaling solution into
the water tank, and then ll the tank
with fresh drinking water up to the
MAX level. Place the tank back into the
machine.
1 Place a container under the steam
wand.
2 Only after adding the descaling solution
in the tank, turn the selector switch
clockwise to the “
” position, and
dispense 2-3 cups of water (approx. 150
ml).
3 Stop dispensing by turning the selector
switch back to its central position “
”.
4 Let the descaling solution take e ect
for 10 minutes.
5 Repeat steps 2 and 3 at intervals of 3
minutes, until there is no descaling
solution left in the water tank.
6 When the “
” light remains steady
on, rinse the tank thoroughly and re ll
it with fresh drinking water.
Loading ...
Loading ...
Loading ...