Loading ...
Loading ...
Loading ...
34
HOW TO TIGHTEN THE ROPES
The ropes may stretch slightly over time. If there is
slack in the ropes before resistance is felt, the ropes
should be tightened. To tighten the ropes, first unplug
the power adapter, and then follow the steps below.
See assembly step 14 on page 21. Remove the
Front and Rear Bottom Covers (67, 109) from the
bottom of the strength system.
See EXPLODED DRAWING B on page 42. Identify
the Rear Shroud (59) on the back of the strength sys-
tem. Remove the four #8 x 3/4" Screws (86) and the
Rear Shroud from the strength system.
See the drawing at the right. Locate a Pulley
Carriage (46). Remove the M8 Jam Nut (106), the
M8 x 33mm Bolt (112), and the Small Pulley (55) from
the upper hole in the Pulley Carriage.
Reattach the Small Pulley (55) to the other hole in the
Pulley Carriage (46). Make sure that the Rope (105)
and the Small Pulley move smoothly.
Locate the other Pulley Carriage (46) and repeat
these actions.
Then, reattach the parts that you removed. Plug in the
power adapter.
55
105
46
46
106
112
Loading ...
Loading ...
Loading ...