Loading ...
Loading ...
Loading ...
12
4. See the upper drawing. Slide a Wall Bracket
(143) onto each side of a Slide Bracket (162).
Align the Slide Bracket (162) assembly along
the centers of the wall studs. Adjust the Wall
Brackets (143) as needed. Using your pencil,
mark the locations of the slots on the wall studs.
Then, remove the Slide Bracket assembly.
Repeat these actions for the other Slide
Bracket (162) assembly.
Using your drill, drill pilot holes in the marked
locations on the wall. Drill 1/4" pilot holes in
wood wall studs. Drill 7/8" pilot holes in metal
wall studs. IMPORTANT: The pilot holes must
be drilled straight and perpendicular to the
center of the wall stud.
Wood Studs. If you are installing the Slide
Bracket (162) assembly in wood wall studs,
see the second drawing. Locate the 3/8" x 3"
Screws (158) and the 3/8" x 1 1/4" Washers
(159). Align a Slide Bracket assembly with two
sets of pilot holes. Using your ratchet or drill,
tighten four Screws with four Washers into the
Slide Bracket assembly and the pilot holes. Start
all the Screws, and then fully tighten them.
Metal Studs. If you are installing the Slide
Bracket (162) assembly in metal wall
studs, see the third drawing. Locate the
M10 x 100mm Toggle Bolts (160). Align a Slide
Bracket assembly with two sets of pilot holes.
Using your ratchet or drill, tighten four Toggle
Bolts into the Slide Bracket assembly and the
pilot holes; make sure to orient the Toggle
Bolts so that the wings (A) will open verti-
cally. Start all the Toggle Bolts, and then fully
tighten them.
Repeat these actions for the other Slide
Bracket (162) assembly.
Make sure that each Slide Bracket (162) is
flush with the wall and that the 3/8" x 3"
Screws (158) or the M10 x 100mm Toggle
Bolts (160) are firmly tightened. Pull firmly on
each Slide Bracket. There must not be any
movement or play in the Slide Brackets.
Then, go to step 5.
4
A
A
158
158
159
159
Wood
Studs
Metal
Studs
143
162
162
162
143
160
160
Loading ...
Loading ...
Loading ...