Loading ...
Loading ...
Loading ...
FAN MOUNTING
Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested you do so in the following manner:
Take the lead wires and make sure you have pulled
them all the way through the top of the downrod.
Start at the TOP of the ball on the downrod and
measure 8 in. of lead wire, and then cut the excess
wire off with wire cutters (not included).
NOTE: If you do not cut back the lead wires, Steps
4 and 5 are not necessary and you may proceed
to Step 6 instead.
4.
3.
Slip downrod (A) into yoke, align holes and
re-install pin (P) and clip (Q). Tighten set screws
and then tighten nuts on the set screws. Slide
yoke cover (E) down until it rests on top of motor
housing (G).
8
4
3
If you decided to cut back the lead wires in Step 4,
strip a 1/2 in. of insulation from end of WHITE wire.
Twist stripped ends of each strand of wire within the
insulation with pliers (not included). Repeat Step 5
for BLACK, BLUE (if applicable) and GREEN wires.
5.
5
Ball
A
8 in.
Set Screws
and Nuts
P
A
Q
G
E
Yoke
Loading ...
Loading ...
Loading ...