Loading ...
Loading ...
Loading ...
5.
Remove pin (P) and clip (Q) from yoke at top of
motor housing (G) and partially loosen
preassembled set screws and nuts.
Remove motor screws (R) and lock washers (S)
from underside of motor housing (G) and save for
later on. Note: If there are plastic motor blocks
installed with the motor screws (R) and lock
washers (S), discard the plastic motor blocks.
INITIAL INSTALLATION
5
FAN MOUNTING
7
1.
1
2.
Insert downrod (A) through canopy (C), canopy
cover (D) and yoke cover (E).Thread wires from
motor housing (G) up through downrod (A).
NOTE: Canopy cover (D) must be turned with the
smooth side toward the motor housing (G).
2
R
S
Set Screws
and Nuts
Yoke
P
Q
G
G
D
A
C
E
G
Loading ...
Loading ...
Loading ...