Loading ...
Loading ...
Loading ...
18
2 Preparation
T Turn the switch to the °position.
MILK/ READY
E You can continue to prepare milk foam for the next
40 seconds or so without the machine having to heat up
again.
To ensure that the fine foam frother always works properly,
you must clean it daily when you have been preparing milk (see
Chapter 5 ‘Maintenance – Cleaning the fine foam frother’).
It is easy to make permanent settings for the amount of water for all
specialty coffees according to the cup size. Adjust the amount once
as shown in the following example. Every time you prepare a drink
in the future, this amount of water will be dispensed.
The process for permanently adapting the amount of water to the
cup size is the same for all specialty coffees.
Example:Proceed as follows to permanently set the amount of
water for one coffee.
Precondition:
CAPPUCC. is displayed (example).
T Place a cup under the coffee spout.
T Turn the Rotary Switch until
COFFEE is displayed.
T Press and hold the Rotary Switch, until
ENOUGH
COFFEE? appears.
T Release the Rotary Switch.
Preparation starts and the coffee flows into the cup.
T As soon as there is sufficient coffee in the cup, press the
Rotary Switch.
Preparation stops.
OK appears briefly on the display. The set
amount of water for one coffee is permanently stored.
COFFEE appears on the display.
E You can alter this setting at any time by repeating the above
procedure.
E You can also permanently set the amount of water for all
specialty coffees in programming mode (see Chapter 4
‘Permanent settings in programming mode – Product
settings’).
Permanently setting the
amount of water for the
cup size
Loading ...
Loading ...
Loading ...