Scotsman Hid312

User Manual - Page 19

For HID312.

PDF File Manual, 25 pages, Read Online | Download pdf file

HID312 photo
Loading ...
Loading ...
Loading ...
HID312, HID525 and HID540
Installation and Users Manual
September 2020
Page 18
Ice level controls
Clean if the controller indicates bin full and there
is no ice between the sensors.
1. Remove upper front and top panels.
2. Shut machine o󰀨.
3. Disconnect ice level controls at connector.
4. Remove 3 screws and ice storage bin cover.
5. Pull each sensor grommet clip up and o󰀨.
6. Push grommets out of bin top.
7. Pull each sensor out of its rubber grommet. Pull
on the part closest to the grommet, not the wire.
8. Wipe the sensor lenses clean with a soft, clean
cloth. Caution - do not scratch the lens. If there
is mineral scale on the lens, ice machine scale
remover will be needed to wipe them clean.
9. Return each sensor to a grommet, push it in until it
snaps into place.
10. Reverse the rest of the steps to reassemble.
Dispensing Bin
The dispensing bin may be removed for cleaning or to
provide service access to other components.
1. Go thru steps 1 thru 10 of the Bin Cleaning
Procedure above.
2. Remove ice sweep.
3. Remove ice delivery chute and chute cover.
4. Remove dispense motor drive pin.
5. Twist and remove the water and ice dispense
chutes.
6. Remove the chute
mounting panel.
7. Remove splash
panel. On Touch-
Free dispensing
models,
disconnect
sensors from
harness and set
panel aside.
8. Locate two 3
prong knob bolts
under the bin.
Remove them.
9. Locate bin drain
and disconnect it
from bin tting.
10. Lift the bin up and
o󰀨 the chassis.
Clean as needed.
Cover
Clip
Sensor
Grommet
Loading ...
Loading ...
Loading ...