Loading ...
Loading ...
Loading ...
4
|
SPECIFICATIONS
Installation Requirements
For portable applications, Wolf grill carts are designed spe-
cifically to fit grill models ICBOG30, ICBOG36 and ICBOG42
and the side burner. Model ICBOG54 is designed for built-in
applications only. (N/A for Australia)
For built-in applications, Wolf outdoor grills and the burner
module are designed for easy placement into a built-in
enclosure. For outdoor grills, installation in a combustible
enclosure requires an insulating liner. For the burner
module, an insulating liner is not required. The enclosure
should be built according to specifications for your specific
installa-tion on page 6. If the burner module is installed next
to an outdoor grill, a minimum of 305 mm is required
between units on the rotisserie motor side and 51 mm on
the oppo-site side. A rotisserie side conversion kit is
available from an authorized Wolf dealer.
Grill carts ( N/A for Australia), insulating liners and stainless
steel doors and drawers are avail able through an authorized
Wolf dealer.
Electrical
Installation must comply with all applicable electrical codes
and be properly grounded (earthed).
The electrical outlet must be located within reach of the
power cord. A separate circuit, servicing only this appliance
is required.
IMPORTANT NOTE: A ground fault circuit interrupter (ELCB)
or residual current device (RCD) is required to reduce the
risk of electrical shock.
ELECTRICAL REQUIREMENTS (GRILL | MODULE)
Electrical Supply grounded, 220-240 VAC, 50/60 Hz
Service 1 A
Receptacle 3-prong grounding-type, IEC inlet
ELECTRICAL REQUIREMENTS (ROTISSERIE)
Electrical Supply—Input grounded, 220-240 VAC, 50/60 Hz
Electrical Supply—Output 12 VDC
Service 0.5 A (6 Watts)
Receptacle barrel plug, 2.1 mm ID x 5.5 mm OD
IMPORTANT NOTE: Connection of this appliance should be
through a fused connection unit or a suitable isolator, which
complies with national and local safety regulations. The on/
off switch should be easily accessible after the appli-ance
has been installed. If the switch is not accessible after
installation (depending on country) an additional means of
disconnection must be provided for all poles of the power
supply. When switched off there must be an all pole
contact gap of 3 mm in the isolator switch. This 3 mm
contact dis-connect gap must apply to any isolator switch,
fuses and/or relays according to EN60335.
Electrical
Shock
Hazard
Plug power cord directly into a properly
grounded (earthed) outlet.
Do not defeat the grounding (earthing)
nature of the plug.
Do not use adapter or extension cord.
Failure to follow these instructions could
cause serious injury or death.
See installation instructions
Gas Supply
Installation must conform with local codes.
Locate the gas supply within the shaded area shown in the
illustrations on page 6.
The outdoor grill is equipped for use with natural or liquid
propane (LP) gas. The product rating plate has information
on the type of gas that should be used. For rating plate
location, refer to the illustration below. If this information
does not agree with the type of gas available, check with
the local gas supply authority.
Where this appliance is installed using fixed gas supply or
reticulated gas supply this Appliance must be installed by
an authorised person in accordance with this instruction
manual, AS/NZS5601.1 Gas Installations, (Installation and
piping) and local fitting regulations.
Outdoor gas grill.
Outdoor module.
RATING PLATE
RATING PLATE
Note - For closed hood cooking it is recommended that only
the center 2 burners are operated and are regulated to
ensure the temperature does not exceed 230 C.
Loading ...
Loading ...
Loading ...